|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
INSTALLATION
Remove the transit bolts
1.Slacken the three or four bolts (according to model) with the spanner supplied. 2.Unscrew the bolts by hand. 3.Hold the screws together with the plastic spacers and remove them. 4.Close the holes with the plastic covers (supplied with the documents). 5.Keep the transit bolts for future use. If the plastic spacers remain inside the machine: Open the rear panel by removing the twelve screws, remove the spacers and replace the panel. Fit the transit bolts before transporting the appliance as follows: 1.Pry off the plastic covers with a screwdriver and remove them. 2.Insert the transit bolts, performing the steps for removal in reverse order.
Adjust the feet
If the floor is uneven, adjust the levelling feet as required (do not insert pieces of wood, cardboard etc. under the feet): 1.Loosen the locknut using the wrench provided. 2.Adjust the height of the foot, turning it by hand. 3.Tighten the locknut anticlockwise towards the washing machine. If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 60 x 60 (40) cm sheet of plywood at least 3 cm in thickness. Secure the plywood sheet to the floor. 111
|
|
|
> |
|
