|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
 ;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
3gb20006.fm Page 27 Thursday, June 5, 2003 2:24 PM
Worktop for built-under models.
The appliance must only be installed beneath a continuous fitted kitchen worktop. If the appliance is to be built under, it is mandatory to use the cover panel UBS. This can be obtained from specialist shops or from After-Sales Service. 1.Unplug the appliance. 2.Unscrew the worktop fixing screws from the rear of the appliance. 3.Lift the worktop slightly to free it from the housing of the top, then slide it forward to disengage it from the control panel, and remove. Install the cover panel following the relative instructions. 4.Refit the fixing screws and tighten them. 5.Plug the appliance back in.
Connect the water inlet hose For models with straight hose:
1.Insert the dirt strainer (included in the accessories) into the threaded tap coupling and the coupling between the hose and the washing machine. 2.Carefully screw the hose connection onto the tap, preferably by hand. 3.Make sure there are no kinks in the hose. 4.Carefully screw the hose connection to the appliance inlet, preferably by hand. 5.Turn the tap on fully and check that the joints at the washing machine and the tap are watertight. If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). Check the hose regularly for brittleness and cracks and replace if necessary. The appliance can be connected without a non-return valve.
Connect the water drain hose
1.Unhook the drain hose from the right clip. Attention: do not unhook the left drain hose connection. 2.Connect the drain hose to the siphon or hook it over the edge of a sink by means of the �U� bend supplied. 3.Make sure there are no kinks in the hose. 4.Secure the hose so that it cannot fall down while the appliance is running. Small hand basins are not suitable. If the hose is to be inserted directly into the drain pipeline, the inside diameter of the pipe must be appropriate in relation to the diameter of the drain hose. If you need to add an extension, use a flexible hose of the same type. Secure the unions with screw-on hose clips. Max. drain hose length: 2.50 m Max. drain height: 90 cm Min.drain height: 60 cm
27
Black process 45.0° 100.0 LPI
|
|
|
> |
|
