|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
30105990GB.fm Page 7 Tuesday, February 13, 2007 11:13 AM
REMOVING THE FILTER/DRAINING RESIDUAL WATER
We recommend that you check and clean the filter regularly, at least two or three times a year.
A
Especially:
� If the appliance is not draining properly or if it fails to perform spin cycles. � If the �Clean filter� indication lights up: IMPORTANT: make sure the water has cooled before draining the appliance. 1. Stop the appliance and unplug it. 2. Remove the plinth or open the cover (depending on the model) by using the separator of the detergent dispenser (fig. A / B). 3. Place a container beneath it. If your washing machine has the filter situated behind the plinth (see pictures �A� and �C�), use a broad and very flat container with a maximum height of 2 cm. 4. Open the filter but do not remove it completely. Slowly turn the filter counterclockwise (fig. C) until the water begins to drain out. 5. Wait until all the water has drained. 6. Now unscrew the filter completely and remove it. 7. Tilt the appliance forwards carefully to allow the water to flow out. 8. Clean the filter and the filter chamber. 9. Check that the pump rotor moves freely. 10. Re-insert the filter and screw it in clockwise as far as it will go. 11. Pour about 1 litre of water into the detergent drawer to reactivate the �Eco system�. Check that the filter is inserted properly and securely. 12. Reinstall the plinth or the cover, depending on the model. 13. Plug in the appliance again. 14. Select a programme and start it.
B
C
GB 7
Black process 45.0° 100.0 LPI
|
|
|
> |
|
