|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
00000gb.fm5 Page 12 Wednesday, May 10, 2000 3:42 PM
DRAINING RESIDUAL WATER
WHEN TO DRAIN RESIDUAL WATER
If the filter needs to be cleaned during a programme. Note: Make sure that the water has cooled before draining. Note: There can be up to 20 litres of water in the machine. � When transporting or moving the machine. � If there is danger of freezing in the installation room. In this case the machine and the hoses should be drained after every wash. � 5. Wait until the flow stops. Note: There can be up to 20 litres of water in the machine during a programme. 6. Clip the drain hose again on the rear part of the machine. 7. Replace the drain hose with the �U� bend and fix it.
DRAINING RESIDUAL WATER
1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Unclip the drain hose connection on the rear part of the machine (see arrow). 4. Lower the drain hose into a container and let the water drain. Note: Make sure that the water has cooled before draining.
WASHING MACHINE INSTALLED IN ROOM EXPOSED TO FREEZING TEMPERATURES
Drain residual water from the machine, and the inlet hose after every wash cycle. 1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Close the tap, loosen the inlet hose from the machine and let the water drain out. 4. Open the filter, let the water drain out and close it again. Note: Before a new wash cycle screw the inlet hose to the machine by hand. Check watertightness of washing machine connections by turning the tap completely on.
12
|
|
|
> |
|
