|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price for the manual and easy to locate on the site and download. I would buy again.
 ;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced. Thanks, I will use you again
;
The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
Great manual, great price. I am very pleased with Owner-Manuals.com, quick service, fast communication. Will definitely use this site again.
;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
CONTROLS
TOP AND FRONT PANEL
English
POWER SUPPLY
CD MODE - to select a different play mode, e.g. SHUFFLE/REPEAT; to programme and review programmed track numbers SEARCH � or § - to skip or search a passage/ track backwards or forward 8 LIFT TO OPEN - to open/ close the CD door RADIO: 9 BAND - to select FM/MW wave band 0 Tuning dial pointer ! TUNING - to tune to radio stations BACK PANEL @ Battery door - to open the battery compartment # BEAT CUT switch - to eliminate any whistle tones during MW recordings $ Telescopic aerial - to improve FM reception % p - 3.5 mm stereo headphone socket Note: Connecting headphones will switch off the loudspeakers ^ AC MAINS - socket for mains lead
1 Source selector - to select source of sound: CD-RADIO-TAPE and also the POWER OFF switch 2 VOLUME - to adjust volume level 3 DBB - Dynamic Bass Boost: for a more vivid bass response CASSETTE RECORDER: 4 PAUSE ; - to interrupt recording or playback STOP�OPEN 9 / - to stop the tape and to open the cassette holder SEARCH 5 or 6 - to fast wind/rewind the tape PLAY 1 - to start playback RECORD 0 - to start recording 5 Cassette compartment CD PLAYER: 6 CD Display - to show the CD functions 7 PLAY�PAUSE 2; - to start or interrupt CD play STOP 9 - to stop playback or erase a programme
BATTERIES Whenever convenient, use the mains supply if you want to conserve battery life. The battery supply will be switched off when the set is connected to the mains. Make sure you remove the plug from the set and wall outlet before inserting batteries.
Batteries (optional)
1. Open the battery compartment and insert six batteries, type R20, UM1 or D-cells (preferably alkaline) with the correct polarity as indicated by the (+) and (-) symbols inside the compartment. 2. Replace the compartment door, making sure the batteries are firmly and correctly in place. The set is now ready to operate. � Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore: � Do not mix battery types, e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. � When inserting new batteries, do not try to mix old batteries with the new ones. � Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly 4
6x R20/UM 1/D-CELL
|
|
|
> |
|
