|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
Mains Supply
Mains Supply
Whenever convenient, use the mains supply if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. Batteries (not included) � When inserting new batteries, do not try to mix old batteries with the new ones. � Remove the batteries if the set is not to be used for a long time.
Using AC Mains
6 x 1.5V R14/ UM2/ C CELL
1 Open the battery compartment and insert six batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "�" symbols inside the compartment. 2 Close the compartment door, and make sure the batteries are �rmly and correctly in place.The set is now ready to operate. � If BATT LOW lights up, battery power is running low.The BATT LOW indicator eventually goes out if the batteries are too weak. Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.Therefore: � Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
1 Check if the mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains cord to the AC MAINS inlet and the wall outlet.The mains supply is now connected and ready for use. 3 To switch off completely, unplug the mains cord from the wall outlet. � Unplug the mains cord from the wall outlet to protect your set during heavy thunderstorms. The type plate is located on the bottom of the set. English 7
Switching power on/off: Save energy
Whether you are using mains or battery supply, to avoid unnecessary energy consumption always adjust the POWER slider to TAPE/OFF and check if the cassette keys are released.
|
|
|
> |
|
