|
Categories
|
Information
|
Featured Product
|
|
|
 |
|
There are currently no product reviews.
 ;
Thanks for this "hard to find" service manual. This Sony PS212A is a very good turntable that needed to be restored !
 ;
Excellent quality on these manuals. Same as having the original printed manual and incredibly useful when doing a custom install like me. Keep it up on the good work.
 ;
This is an excellent information source. Great quality and tons of info regarding technical service for the Technics SH8065.
 ;
5 stars on this manual since it is the complete version, not the half manual you find free for download all over the web. Good job.
 ;
Thank you very much you are helping me a lot with my preferred hobby!!! this manual of an old TV is going to be very helpful!!!!
You are very honest competent great job very clear and well done!!!!
Matteo
English CONTROL/POWER POWER SUPPLY DIGITAL TUNER
& Battery compartment 6 batteries, R-14, zinc. Only use batteries of same type for the set. 1 x AC mains lead Tuning to radio stations
^ AC MAINS inlet for mains lead. � Do not mix battery types: e.g. alkaline with carbon ACCESSORIES DIGITAL TUNER
UM2 or C-cells. � When inserting new batteries, do not try to mix old 1 x Remote Control
1. Adjust the POWER OFF/TUNER/CD to TUNER.
batteries with the new ones. � tu is displayed briefly and then the radio a preset number are shown. (See )
OFF)
TOP AND FRONT PANEL (See 1 ) REMOTE CONTROL � Batteries contain chemical substances, so 1 LIFT TO OPEN lift here to open MP3-CD door. they should be disposed of properly. 1 VOLUME 3 , 4 adjusts volume level.(up, down) 3 2 POWER selects CD/TUNER 2 SHUFFLE plays all CD tracks in random order. OFF/TUNER/CD function and also the power off switch (POWER 3 2; starts CD playback;
station frequency, waveband and, if programmed,
pauses CD playback
2. Press CD MODE/BAND once or more to select Using AC Power your waveband. 1. Check if AC power supply, as shown on the 3. Press and hold SEARCH or § until the
3 DBB (Dynamic Bass Boost) activates a more vivid bass response frequency in the display starts running. 4 CD MODE/BAND � The radio automatically tunes to a station of
4 SEARCH 5 , 6 searches backwards/
type plate located on bottom of the set,
CONNECTIONS AND CONTROLS
5 PRESET + ,(up, down)
forwards within a track.
corresponds to your local power supply. If it does
5 0-9: digit panel from the wall socket. 7 9 stop MP3/CD playback; desired station. 6 Display shows status of the set.
selects different play modes: e.g. REPEAT or not, consult your dealer or service centre. sufficient reception. Display shows Srch TUNER: selects a preset radio station (random) order 2. Connect mains lead to the wall socket. MP3 only: selects previous/next album during automatic tuning. SHUFFLE selects waveband 3. To disconnect mains supply, unplug the set 6 TUNING , § (down, up) tunes to tuner stations. 4. Repeat step 3 if necessary until you find the
MP3/CD: track selection and direct playback erases a MP3/CD program. TUNER: selecting a preset station 8 ¡ , � skips to the beginning of a current track
To tune to a weak station, press or § briefly The type plate is located on bottom of the set.
and repeatedly until you have found optimal reception.
previous/ subsequent track.
9 REPEAT repeats a track /program/ entire CD.
This set complies with the radio interference 7 PROG To improve radio reception:-
MP3/CD: programs tracks and reviews requirements of the European Community. � For FM, extend, incline and turn the telescopic � For MW (AM)/LW, the set uses a built-in aerial. Direct this aerial by turning the whole set.
3-2
aerial. Reduce its length if the signal is too strong. TUNER: programs preset radio stations. Use of controls adjustments or performance For users in U.K., please follow the boxed
CAUTION program; of procedures other than herein may result in hazardous radiation exposure or other unsafe
instructions �Important notes�� on this sheet. 9 9 stop MP3/CD playback;
8 2; starts or pauses MP3/CD playback.
operation. erases a MP3/CD program. Programming radio stations BASIC FUNCTIONS Switching on off and selecting function POWER SUPPLY 1. To switch on, adjust the POWER OFF/TUNER/CD ! ALBUM (+, -) Whenever convenient, use the AC power supply to to select: CD or TUNER function, and operate the Manual programming MP3 only: selects previous/next album conserve battery life. Make sure you remove the respective function controls. 1. Tune your desired (see Tuning to radio TUNER: selects the previous /next preset station power plug from the set and wall outlet before
0 Remote Sensor infrared sensor for remote You can store up to a total of 40 radio stations in the
control memory, manually or automatically (Autostore).
@ SEARCH , § � On and then tu or Cd are shown briefly when you stations). inserting batteries.
MP3/CD: searches backward / forward within switch on the selected function. 2. Press PROG to activate programming. (preferably alkaline) with the correct polarity. (See ) track/ previous/ later track volume level 20) will be retained in the set�s memory. want to store your station as preset 11.(See ) (preferably alkaline). (See ) Adjusting volume sound (See 2 ) display will show noPr and tune to Pr 4. Presets 1. Adjust volume with the VOLUME controls. exceeding 50, e.g. 67 will tune you to presets 6 and 7. BACK PANEL 7
a track; 2. To switch off, adjust the POWER OFF/TUNER/CD � Display: Pr -and PROGRAM flashes. select POWER 3. Use digit panel on the set to key in a number, OFF.
Batteries (not included) � Insert 6 batteries, type R-14, UM-2 or C-cells, skips to the beginning of a current
# VOLUME 3 , 4 to adjust volume level up/down Insert 2 batteries, type AAA, R03 or UM4
TUNER: (down, up) tunes to radio stations. � Remote control 4
Note : The DBB setting, tuner presets and the volume (up 1-40, to select a preset station. E.g. press 1,1 if you
Note : If a higher preset number, 41-49 is selected, the 9
IMPORTANT! $ Telescopic aerial improves FM reception. � Display shows the volume level UoL and a � Remote control: Press PRESET / once or � Incorrect use of batteries can cause electrolyte + % p 3.5 mm stereo headphone socket. number from 0-32. more to select a preset station. Note: The speakers will be muted when headphones 2. Press DBB once or more to select dynamic bass � Set: press ALBUM (+ /
-
are connected to the set. boost on or off. 4. Press PROG to confirm.
leakage and will corrode the compartment or cause the batteries to burst.
-)
|
|
 |
> |
|