|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent quality, helped to fix problem. Thank you very much!!!!
;
I thank Owner-Manuals.com for providing the necessary manual very quickly, and it was very helpful in repairing my personal Audio System and I once again thank them for the wonderful customer's service satisfaction.
Thanks.
;
Everything fine: quick service, no glitch and above all a very good quality of the Pdf file. Thank you!
;
The manual was complete, parts list, adjustment procedures, etc. No worries
 ;
Very usefully, I could find the trouble clearly with that manual.
3-2
CONNECTIONS AND CONTROLS
& * ( ) ¡
6 x R20 � UM-1 � D-CELLS
BACK PANEL & Telescopic aerial � improves FM reception * Battery compartment � for 6 batteries, type R-20, UM1 or D-cells ( Voltage selector (inside battery compartment, some versions only) � adjust to match the local voltage 110/220V before plugging in the set ) p � 3.5 mm stereo headphone socket Note: The speakers will be muted when headphones are connected to the set. ¡ AC MAINS � inlet for mains lead
Using AC Power 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service centre. 2 If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains. 3 Connect the mains lead to the wall socket. 4 To disconnect the mains supply, unplug the set from the wall socket. Auto-Standby mode When a CD or tape has reached the end of playback and remains in the stop position for more than 15 minutes, the set will switch off automatically to save power.
POWER SUPPLY Whenever convenient, use the power supply to conserve battery life. Make sure you remove the power plug from the set and wall outlet before inserting batteries. Batteries (not included) � Insert 6 batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity. Remote control (for AZ2045 only) � Insert 2 batteries, type AAA, R03 or UM4 (preferably alkaline). Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. � Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. � When inserting new batteries, do not try to mix old batteries with the new ones. � Batteries contain chemical substances, so they should be disposed of properly.
For more information on operation instruction please visit Philips Audio internet site : http://www.audio.philips.com
|
|
|
> |
|
