|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great scan but please note that it is entirely in GERMAN.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
B5R Bass Amplifier The Rear Panel:
21 24 25 26 27 28
22
23
29
30
31
32
21. CIRCUIT BREAKER: The B5R employs an AC line circuit breaker to help protect against damage due to excessive current demands. If the amplifier stops working, check the circuit breaker. If it has opened, the button will be protruding and showing a contrasting color. You can reset the circuit breaker by pushing it in until it latches. The breaker must cool down for a short time before the button will latch. If the circuit breaker opens repeatedly, have the amplifier checked by a qualified service person. 22. AC LINE IN: Firmly insert the supplied AC power cord into this socket until it is fully seated. Plug the male end of the cord into a grounded AC outlet. DO NOT DEFEAT THE GROUND PRONG OF THE AC PLUG! 23. SPEAKER OUTPUTS: The 1/4� jacks offer a convenient method of connecting to speaker cabinets using cables terminated with 1/4� plugs. However, when using the amplifier at or near its full output power, using the Speakon® jack is recommended. 24,25. TRANSFORMER BAL. LINE OUT: These jacks supply a pre-Master, line level signal for connection to a house mixing board, recording console or external amplifier(s). The 1/4� jack (24) provides a balanced or an unbalanced signal (depending on the signal cable used); the XLR-type jack (25) provides a balanced signal. 26. EFFECTS LOOP RETURN: When using external effects, connect the effect�s output into this jack by means of a shielded instrument cable.
27. EFFECTS LOOP SEND: When using an external signal processor, connect this jack to the input of the effect by means of a shielded instrument cable. 28. TUNER OUT: This jack is provided for connection to an electronic tuner and is always �live,� even when the Mute switch (3) is engaged, allowing for �silent tuning� as well as a monitor feed which remains active when the other outputs are muted. 29. POWER AMP INPUT: This jack connects directly to the power amp for use with an external preamp. When using an external source, connect the OUTPUT of the source to this jack by means of a shielded instrument cable to feed the signal into the power amp section. The internal signal is disconnected when a plug is inserted. 30. PREAMP OUTPUT: This jack is a direct preamp output for use with an external power amplifier, mixing board, external effects, etc. Connect the external unit input to this jack by means of a shielded instrument cable. Using this output does not break the connection to the internal power amplifier. 31. OCTAVE/COMBINE FOOTSWITCH: Connect a two button footswitch to this jack for remote control of the Octave and Combine features. The tip connection controls the Octave feature and the ring connection controls the Combine feature. 32. CHANNEL FOOTSWITCH: Connect a single button footswitch to this jack for remote channel selection.
Speakon® is a registered trademark of Neutrik AG.
5
|
|
|
> |
|
