|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
 ;
The purchased manual is an scan of the original Panasonic paper-based Service Manual. Unfortunately the contrast is not perfect, but I am satisfied anyway!
;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
4-48
Forsyningsspeqdingetr En pil og spandingen viser, hvor forsyningsspendiqgerne gfr ind i et prinl Eksempel: (7 CON.) feks. ved siden af forsyningsspendingen angiver det antal stedet, spandingen gtr ind pi denne diagramside.
\
4-48
Supply Voltage An arrow and the voltage show where the supply voltages are fed to a PCB. Example: (7 CON.) next to the supply voltage indicates the number of places where to find the voltages in this diagram.
Symbol for sikkerhedskomponenter
d-
for Safety Components
Ved udskiftrting af komponenter med dette symbol skal der anvends komponenter med samme reservedelsnummer. Den nye komponent skal monteres pi sammemtde som den udskiftede.
When replacing componentswith this symbol components with identical part numbers are to be used. The new component must be fitted in the same way as the one replaced
uArJBBrnqCBrsBn
Alle DC spandinger er milt i forhold til stel, med voltrneter med en indgangsmodstandpA 10 Mohm. Spendingerne er milt uden signaltilforing.
MEAST'RING coNDITIoNS
All DC voltages have been measured in relation to ground with voltneter with an input resistance of 10 Mohms. The voltages have been measured without any supply of signal.
|
|
|
> |
|
