|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
2.1
Warnings � Insulating test
Warnings
ESD STATIC ELECTRICITY MAY DESTROY THE PRODUCT
When electrical replacements or disassembly is taking place, use an ESD-mat. The internal electronics are very sensitive to static electricity. Handling Wear cotton gloves to avoid any �ngerprints on the product. The surfaces on the product are very sensitive, so handling should be done with great care to avoid damage. Cleaning of the speaker surfaces should only be done with a lint-free cloth which you have dipped in lukewarm water and wrung �rmly.
Insulation test
The product must be insulation tested after having been dismantled. Make the test when the set has been reassembled and is ready to be returned to the customer. Flashover must not occur during the test. Make the insulation test as follows: Short-circuit the two pins of the mains plug and connect them to one of the terminals of the insulation tester. Connect the other terminal to ground on the Power Link socket. NOTE! To avoid damaging the product it is essential that both terminals of the insulation tester have good contact. During the test the current must not exceed 5 mA. Slowly increase the voltage on the insulation tester until a voltage of 2.5 kV (ac) is obtained. Maintain the voltage level for one second, then slowly decrease the voltage to 0 V (ac).
|
|
|
> |
|
