|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
2. Pkk the right window. First, decide what
room(s) you want to cool. Then choose a window that will allow the air-conditioned air to flow freely and directly into the room(s) you want cooled. Remember, it�s difficult to move air around comers. Choose a window that is also near an electrical outlet. (See �Electrical Requirements� on pages 3-7 for receptacle and wiring needs.) Do not use and extenslon
cord.
The window in which you place your air conditiiner should have an opening of at least 26 inches (66 cm) in width and at least 20 inches (51 cm) in height. Standard installation parts are supplied for double-hung sash windows up to 54 inches (137 cm) in width. 3. Remove front panel by pushing top of panel down and out. This protects the panel from damage and makes the air conditioner easier to handle during installation. 4. Slide unit out of cabinet First, disconnect the green ground wire at the left-front corner of base of unit by removing retaining screw (save screw for reuse in step 18). Now slide unit out of cabinet by pulling out on handle at base of unit.
Groundwire saw
5. Attach eeal etrlps to cabinet. Place
?@ (9 mm)-wide self-adhesive seal strip on window side of bottom flange. Now, starting at the bwer corner of the cabinet, apply ?4? (9 mm)-wide seal strips over the center line of the pre-drilled holes for one of the side mounting angles, over the center line of predrilled holes for the top mounting channel, and over the center line of predrilled holes for the other side mounting angle.
9
|
|
|
> |
|
