FEATURE AND FUNCTIONS
True to the Music
www.radialeng.com
True to the Music
1
2
INPUT - ¼� jack for instruments like guitars and bass. DRAG - recessed control adjusts the amount of load on the pickups. Full clockwise is max input impedance (approximately 1MegaOhm) and produces a bright tone. Turning counter-clockwise will increase the load on the pickups and darken the tone. GAIN - recessed control adjusts the level of the footswitchable power boost. Full counter-clockwise is unitygain (no boost). Full clockwise is max boost (+15dB). The PB1
4
is designed to amplify the input signal without adding distortion or changing the tone. 9VDC - connection jack for standard 9 volt power adaptors (center tip negative). OUTPUT - ¼�, low impedance output for driving high capacitance loads like long
BIGSHOT PB1 SPECIFICATIONS Connections: .............. ¼� instrument in and out Input impedance: ....... variable Drag control (10K ~ 1meg) Gain: ........................... unity to +15dB Power requirement ..... 9 Volt DC, center negative Current draw: ............. 40mA max with LED on Size: ........................... 3� x 3� x 2�
BigShot PB1 Owner�s Manual
5
cables and lots of pedals without high frequency loss.
6
3
LED - super-bright LED status indicator lights when power boost is active. FOOTSWITCH - heavy-duty switch toggles the power boost on and off.
7
LIMITED THREE YEAR TRANSFERABLE WARRANTY
Radial Engineering warrants this product to be free from defects in material and workmanship and will remedy any such defects free of charge according to the terms of this warranty. Radial Engineering will repair or replace at its option any defective component(s) of this product, excluding the �nish, the footswitch (footswitch is warranted for 90 days) and wear and tear from normal use, for a period of three (3) years from the original date of purchase. In the event that a particular product is no longer available, Radial Engineering reserves the right to replace the product with a similar product of equal or greater value. To make a request or claim under this limited warranty, the product must be returned prepaid in the original shipping container (or equivalent) to Radial Engineering or to an authorized repair centre and you must assume the risk of loss or damage. A copy of the original invoice showing date of purchase and the dealer name must accompany any request for work to be performed under this limited warranty. This limited warranty shall not apply if the product has been damaged due to abuse, misuse, misapplication, accident or as a result of service or modi�cation by any other than an authorized repair centre. THERE ARE NO EXPRESSED WARRANTIES OTHER THAN THOSE ON THE FACE HEREOF AND DESCRIBED ABOVE. NO WARRANTIES, WHETHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, SHALL EXTEND BEYOND THE RESPECTIVE WARRANTY PERIOD DESCRIBED ABOVE OF THREE YEARS. RADIAL ENGINEERING SHALL NOT BE RESPONSIBLE OR LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LOSS ARISING FROM THE USE OF THIS PRODUCT. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH MAY VARY DEPENDING ON WHERE YOU LIVE.
4
3
2
5
1
6
7
Radial Engineering 1638 Kebet Way, Port Coquitlam BC V3C 5W9 Tel: 604-942-1001 Fax: 604-942-1010 email:
[email protected]
Radial BigShot PB1 users guide v1.0 - Part #: R870 1150 00 Subject to change without notice
Radial Engineering
BigShot PB1 User Guide
Radial Engineering
BigShot PB1 User Guide
