|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
1-7. Rack Mounting
5. For installing the unit in the rack, press the inner members fully to the outer members while pressing the stoppers of the inner members. c � Be sure to mount the unit in the rack with two-person or more. Trying to handle this job by a one-person could lead to injury. � Be careful not to get caught your hand and finger in the rack mount rail when installing the unit in the rack.
Rack
7. After installing the unit in the rack, secure the unit to the rack by the prepared four screws (RK5 X 16) and four washers.
Rack
Washers
RK5 X 16
DME-3000/7000 RK5 X 16 Washers
Outer member Stopper Inner member DME-3000/7000
6. After confirming that the unit can be moved smoothly, tighten the screws (B5 X 8) secured temporarily in the step 4. n When securing the front brackets to the rack by screws, pull out the unit about 20 cm (8 inches) from the rack, and fasten the screws of the front brackets to the rack.
1-13 (E)
|
|
|
> |
|
