|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
1-10
Installing the Input Adaptor
Rewriting the Service Mode Status
CN3
8
Adjust the main bracket position. Insert the B block in the CN4001 and the CN4003 on the A board.
You need to rewrite the service mode status so that the input adaptor can accept HD SDI signals. The following shows how to do this.
3
Press the MENU/EXIT and ENTER/SELECT buttons as needed to display �SDI EXIST 0 216� on the screen.
MENU SELECT
B block
1
Press the MENU/EXIT button on the monitor. The main menu appears.
MENU
EXIT MENU
COLOR TEMP ADJ... INPUT CONFIG... SYSTEM CONFIG... SERIAL REMOTE...
ENTER
SDI EXIST
0 216
EXIT
SELECT ENTER
MENU
A board CN4003 CN4001
After Installing the Input Adaptor
2
1 9
Connect the IN/MONITOR OUT plug (BNC connector installed in Step 5) to the IN/OUT (B block connector).
Return the G board installed in Step 5 in �Before Installing the Input Adaptor� to the original location. Lock the board with the two screws.
To go to the service mode, press the DEGAUSS and ENTER/ SELECT buttons at the same time. The service mode status menu appears.
SELECT
4
Using the +/� button, change �0� to �1� in �SDI EXIST 0 216.�
RESET
2
Reconnect the cables removed in Step 3 in �Before Installing the Input Adaptor�. Slide the main bracket back into the unit until it is set in the original place. Insert the fan connector removed in Step 1 in �Before Installing the Input Adaptor� into the monitor connector. Use the screws (12) to install the rear cover of the monitor.
Note
DEGAUSS
BTA 1125 N/S H. SIZE 238 3
ENTER
SDI EXIST 1 216
3
5
Press the DEGAUSS button. The �WRITE� message appears.
10Connect the cable (red/yellow/
black) from the B block fan to the CN 3 connector on the GC board.
You cannot turn on the power unless you connect the fan connector.
Note
DEGAUSS
SDI EXIST 1 216 WRITE
Reinstall the components and cables just as they were before installation was begun.
(Continued)
20
21
|
|
|
> |
|
