|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
 ;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
;
Complete MFG Service Manual at a good price FAST !
3-3. Replacing the Main Parts
3-3-2. DC Fan
n The DC fan can be replaced with the main power of the MAV-2000 turned on. When replacing the DC fan while the powers are on, do it as quickly as possible (within about 10 minutes) in consideration of the air-cooling effect. Replacement Part Part name : DC fan Part No. : 1-763-175-11 Replacement Procedure 1. Open the front panel. (Refer to Section 3-1-1.) 2. Turn off the power of the switching regulator. 3. Remove the four screws, and while holding the handle remove the fan assembly in the direction of the arrow.
Replacing the right DC fan 1. Disconnect the harness from the two harness clamps. 2. Disconnect the connector (CN2) of the LE-193G board. 3. Remove the four screws and remove the DC fan.
Replacing the right DC fan
LE-193G board
Harness clamps
Harness DC fan
CN2 B4 x 35
Fan assembly
B4 x 35
4. Attach a new DC fan to the fan assembly in reverse order of steps 1 through 3.
Handle
BVTT3 x 6
Replacing the left DC fan 1. Disconnect the harness from the harness clamp. 2. Disconnect the connector (CN3) of the LE-193G board. 3. Remove the four screws and remove the DC fan.
Replacing the left DC fan
Harness clamp
BVTT3 x 6 Fan assembly
CN3 LE-193G board
n Only the right or left DC fan can be replaced.
Harness
B4 x 35 Fan assembly DC fan B4 x 35
MAV-2000
4. Attach a new DC fan to the fan assembly in reverse order of steps 1 through 3. 3-5 (E)
|
|
|
> |
|
