|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
http://getMANUAL.com
4-5. DA-136 Board Adjustment
4-5-2. D/A Video Level Adjustment
m Check the following setup menus before starting adjustment. . Check the NTSC/PAL setup. (Refer to menu No. 010 of Section 1-9-2 of the MAV-555 Installation Manual.) . Check the network setup. (Refer to menu No. 220 of Section 1-9-6 of the MAV-555 Installation Manual.) Connection
MAV-555 + BKMA-512
Setting 1. Open �782-INT VD SG R1� of the setup menu. n For details on how to use the setup menu, refer to the Operation Manual. 2. Press the VIDEO/MENU knob once.
782-INT VD SG R1
off
3. Turn the VIDEO/MENU knob and select �CB100�
VIDEO OUT* P1-A or P2-A ETHER Ethernet
(100% color-bar signal).
782-INT VD SG R1
CB100
4. Press the SET button. 5. Set �703-OUT SETUP P1� or �704-OUT SETUP P2� to �off� on the setup menu in accordance with the port that the BKMA-512 is connected to. (Refer to Section
Waveform monitor or an oscilloscope
PC
1-9-5 of the MAV-555 Installation Manual.) n The setting is not required in case of the 625-mode (PAL). 6. Turn off the main power and back on. Restart the MAV-555. n To restart the MAV-555 quickly, execute �027-FAST REBOOT� of the setup menu. 7. Press the R1 button on the PORT SELECT block of the meter panel. (Set so that the internal SG is output to the R1 port.) 8. Press the COMPOSITE button of the VIDEO INPUT SELECT block of the meter panel for at least three seconds. (The internal SG starts, and the COMPOSITE button and the SDI button are turned on.) 9. Press either the P1 or the P2 button of the PORT SELECT block of the meter panel in accordance with the port to which the BKMA-512 is connected. 10. Press the CONTROL button of the VIDEO PROCESS block on the meter panel several times, and enter the LOCAL mode. 11. Set all buttons of VIDEO, CHROMA, SETUP, and CHROMA PHASE on the meter panel to �PRESET�.
* : Connect to the VIDEO OUT P1-A or the VIDEO OUT P2-A in accordance with the port to which the BKMA-512 is connected.
MAV-555
4-11 (E)
|
|
|
> |
|
