|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
 ;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
;
Excellent service manual with all the necessary info. :)
;
The product dowload was delivered efficiently with emails to support its download availabilty. The contets of the manual was very eligible and of good quality. Will purchase from this site again!
5-5. AT Head Cleaner Replacement
Removal 1. Remove the CL Arm Assembly (1) Turn the M gear of the gear box assembly manually and move the CL arm assembly to the position shown in the figure. n Move the CL arm assembly to the front of the SE-341 board. If not, the CL arm assembly cannot be removed because the stop washer is hidden by other parts. (2) Remove the stop washer at the top of the CL arm assembly. (3) Remove the CL arm assembly from the threading ring. n Do not remove the spring at the bottom of the CL arm from the shaft.
Hole M gear Gear box assembly CL arm assenbly
SE-341 board
CL arm assembly
Stop washer
Installation 2. Attach the CL Arm Assembly (1) Pass a new CL arm assembly through the shaft while hooking the spring as shown in the figure. n Insert the short-end of the spring into the groove of the threading ring and the long-end spring into the hole of the CL arm assembly. (2) Fix the CL arm assembly by new stop washer.
Remove the CL Arm Assembly
SE-341 board Threading ring Shaft Spring
Groove
Stop washer (2.3) : 3-669-596-00
DNW-A100/A50/A45 DNW-A100P/A50P/A45P
5-33
|
|
|
> |
|
