|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
2-3. Disconnecting/Connecting of Flexible Card Wire
Connecting m Be careful not to insert the flexible card wire obliquely. Check that the conductive surface of the flexible card wire is not soiled with dust. CP-295 board side 1. Slide the portions B in the direction of the arrow and insert the flexible card wire as far as it will go into the connecter with the conductive surface of the wire faced as shown in the figure. 2. Slide the portions B in the opposite direction of the arrow to lock.
Conductive surface B
3. Route the flexible card wire around the lead pin as shown in the figure.
Front panel
S24 CP-295 board
S25
CN1 Lead pin Frexible card wire
AU-236 board side 1. Slide the portions A in the direction of the arrow and insert the flexible card wire as far as it will go into the connecter with the conductive surface of the wire down. 2. Slide the portions A in the opposite direction of the arrow to lock.
A Conductive surface
BKP-5973
2-3 (E)
|
|
|
> |
|
