|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
1-3. Installation of BKP-7311
1-3. Installation of BKP-7311
1. Disconnect the power cord from the rear panel of CCU-700A. Loosen the two screws(M4 x 20) and remove the front panel. 2. Push and turn the eject levers to unlock and pull out all the plug-in boards from the unit.
Unlock Unlock
4. Remove the six screws(B3 x 5) and open the rear panel. Disconnect CN3 connected to the rear panel.
Flexible card wire MB-563 board CN-3
Plug-in boards B3 x 5
Rear panel B3 x 5 Front panel B3 x 5
3. Loosen the four screws(PWH4 x 10) fixing the power unit and remove the power unit while pushing the power unit forward at the fan in the rear of the unit.
5. Install the three coaxial cables into the supplied harness guide.
Power unit Coaxial cables
Harness guide
Screws (PWH4 x 10)
Screws (PWH4 x 10)
1-2(E)
BKP-7311
|
|
|
> |
|
