|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
un manual completo con una calidad de imagen buena con explicaciones en varios idiomas de los ajustes y detalles en conjunto un OK.
;
Good copy, clear and has all necessary information. Very happy with the purchase
 ;
buen manual con sus formas de onda y esquemas , completo y de buena calidad de imagen, es correcto.
;
This is exactly what I needed This was a hard one to find and I had already downloaded several for other Panasonic radios but none matched my radio.
Although my radio is the LBE model the LBS is the same.
A very good quality manual with every thing you should get in it
;
el manual es correcto , completo y de buena calidad aunque algun esquema esta excesivamente diseccionado.
1-3. Self Diagnostics
6. The switches S2 and S4 can be diagnosed as follows. (1) Press the [Return] key once and confirm that the following message appears on display. Then set the switches S2 and S4 as shown below.
BKP-7933 IF-689 Board Check START !! S-BUS COMMUNICATION SYSTEM -----------------------M27C4002(IC6,7 EPROM) ----------------------------STK12C60-S45(IC501,502,503,504 NVRAM) ------------CY7C109-20VC(IC8,9,10,11 SRAM) -------------------HN58257AT(IC28,29,30,31 EEPROM) ------------------IDT7133/7144SA55J(IC301,302 D.P.RAM) Rport ---------------------------------------------------------UPD71055 (IC42,43 PIO) MODE SW CHECK-A(S2,S4) ----OK OK OK OK OK OK **
12345678
(2) (3)
Pressing the [Return] key again starts diagnostics, and the result is displayed. Press the [Return] key once and confirm that the message �MODE SW CHECK-B (S2, S4)� appears on display. Then set the switches S2 and S4 as shown below.
12345678
(4) Pressing the [Return] key again starts diagnostics, and the result is displayed. 7. The switch S12 can be diagnosed as follows. (1) Confirm that the message �S-BUS NO CHECK-A (S12)� appears. Set the switches in the same manner as step 6 -(1) and execute diagnostics. (2) Confirm that the message �S-BUS NO CHECK-B (S12)� appears. Set the switches in the same manner as step 6 -(3) and execute diagnostics. 8. The switch S3 can be diagnosed as follows. (1) Press the [Return] key once and confirm that the message �CNU GP NO CHECK-A (S3)� appears on display. Then set the switch S3 as shown below. S3 (CNU GP No) � 0 (2) Pressing the [Return] key again starts diagnostics, and the result is displayed. (3) Press the [Return] key once and confirm that the message �CNU GP NO CHECK-B (S3)� appears on display. Then set the switch S3 as shown below. S3 (CNU GP No) � F (4) Pressing the [Return] key again starts diagnostics, and the result is displayed.
1-4 (E)
BKP-7933
|
|
|
> |
|
