|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Response is a little slow- I had to wait 12 hours to receive download link but it says that it may take up to 24hrs.
Manual is old and was not produced in PDF- scanned copy is exellent.
Overall- value for money- I recommend
 ;
Excellent quality and quickly delivered manuals at a fair price. Great care is taken in the reproduction process. Even photographs and highly detailed drawings are as clear as in the original. That cannot be said for some freelance manual copies I have obtained from the web. If you have exhausted your internet search of technical manuals, try Owner-Manuals.com. If they do not have it, I do not think it exists. Perhaps, if requested, they may be able to find it. Their resources are certainly greater than most. Shopping here certainly beats waiting for months or years for the manual you seek to appear in an internet auction or garage sale.
;
Very detailed product, also it is a scanning from original, very useful if you have to service this type of amplifier ! Very good product, very hard to find!
;
the Manual was made available as promised, the scans were excellent..Good Work !!!
;
It's complete and helpful manual with good quality of scan. Thanks very much.
2-6. Word Sync Output Waveform Confirmation
2-6. Word Sync Output Waveform Confirmation
Preparation 1. Connect each equipment. (Refer to Fig.1 in Section 21-2.) 2. Extend the AVM-6 board using an extension board. 3. Turn on the power of the main unit (PFV-D20/D50/ D100A/D200A/D300) and warm up for ten minutes. Measurement Equipment Oscilloscope Procedures 1. Confirm that S802 (P-8) is set to NORMAL. 2. Provide the output signal from the WORD SYNC OUT connector to the CH1 of an oscilloscope using a coaxial cable. At that time, terminate the input connector of the oscilloscope using 75 Z feedthrough terminator. 3. Observe a waveform in the DC coupling mode of the oscilloscope and confirm that the waveform below is displayed.
0.50 ±0.03 Vdc 0 Vdc _0.50 ±0.03 Vdc 20.8 µs (48 kHz)
4. Confirm that the waveform below is displayed when S802 is set to HIGH.
2.6 ±0.1 Vdc
0 Vdc 20.8 µs (48 kHz)
_0.3 ±0.1 Vdc
2-8(E)
BKPF-105A
|
|
|
> |
|
