|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
El producto satisface las necesidades del servicio t
;
This is a good quality scan of the Operation & Maintenance (Service) Manual for the PAL version of this high-band broadcast umatic, BVU-800P
All schematics and lineup procedures appear to be included in this one manual AFAICT.
The file size is just over 113 MB which gives an idea of the quality and number of pages.
All of the schematics, which contain some fairly small print, are easily readable when you zoom into the page.
John Thompson, Newcastle Upon Tyne, England.
;
Good quality, all schematics of few of models. There is also short form of user manual and regulation manual.
;
Perfect copy of the service manual. you can enlarge every page, and it comes up
with all details.
;
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
2-1. Electrical Alignment Overview 2-2. Preparations for Adjustment
2-1-3. Initial Settings
VDA-44 Board
S301
1 RV204 1 RV202 1 RV203 1 RV201
E2 TP1
S1
ON OFF
1
RV1
OFF ON
TP2 TP7
ON OFF
S3
RV2
1
1 RV401
Component side (A side)
Set the switches of the S301 before the adjustment as follows: (The marks indicate the switch lever position.)
ON 1 2 3 4 5 6
ON
S301 settings for 525 mode
1
2
3
4
5
6
S301 settings for 625 mode
n When switching the switch lever position from a customer-set position, use the table below to note down the setting state of the customer. After completing the adjustment, be sure to reset the switches to their customer-set position.
Ref.No. S301-1 S301-2 S301-3 S301-4 S301-5 S301-6 Setting during adjustment (Function) 525 mode 625 mode OFF (525 line) ON (Component) OFF (YUV) ON (7.5 % Setup) OFF (Rounding OFF) Don�t care ON (625 line) ON (Component) OFF (YUV) OFF (0 % Setup) OFF (Rounding OFF) Don�t care Customer-set position
2-2. Preparations for Adjustment
1. 2. 3. 4. Extend the VDA-44 board with the extension board EX-668. Connect the equipment and tools. (Refer to Section 2-1-2.) Set the switches on the VDA-44 board. (Refer to Section 2-1-3.) Turn on the power of the PFV-L1 and warm up the unit for about 10 minutes.
2-2(E)
BKPF-L613C
|
|
|
> |
|
