|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
1-8. Replacing the Boards
1-8-3. LE-195 Board
1. Remove the front panel. (Refer to Section 1-2.) 2. Remove the power supply unit which contains the LE195 to be replaced. (Refer to Section 1-6.) 3. Remove the one screw at the front side of the power supply unit. 4. Disconnect the connector CN1. 5. Install a new LE-195 board in the reverse order of steps 1 to 4. n To install the LE-195 board, insert a projection of the LE-195 board into the hole in the power supply unit.
1-8-4. LF-46 Board
1. Remove the front panel. (Refer to Section 1-2.) 2. Remove the power supply unit which contains the LF46 board to be replaced. (Refer to Section 1-6.) 3. Disconnect the three connectors (CN2, CN3, and CN4). 4. Remove the four screws, then remove the LF-46 board. 5. Install a new LF-46 board in the reverse order of steps 1 to 4.
PSW 3x8
CN4 CN2 CN1 CN3
LE-195 board
LF-46 board
B 3x6
Projection
PFV-L1
1-7(E)
|
|
|
> |
|
