|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
 ;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
;
Perfect like it was descriped, Perfect like it was descriped
;
Very good detail, all pages clear, exactly what I needed
2-1. Self Diagnostics Using a Personal Computer
2-1-2. Diagnostic Test Using the �adiag� Command
The �adiag� command performs the diagnostic operation of the record/playback blocks and the CPU peripheral hardware of the BKSI-2010/2011. Procedure 1. Start up the personal computer. (Refer to section 2-1-1.) 2. Turn on the main power of the SIU-80. Each outer segment of the 7-segment LED (D3304) on the SCS-4 board blinks in a clockwise direction sequentially. The �SDC>� prompt appears on the personal computer display to enter a command. n If the �SDC>� prompt does not appear, press the ENTER key. 3. Enter �adiag� and press the ENTER key. The diagnostic test is started. The test items in progress appear on the display. n If the BKSI-2011 (MY-72 board) is installed, the �Extend PB Memory detected.� message appears on the personal computer display. If the message �Extend PB Memory detected.� does not appear even through the MY-72 board is installed, check that it is correctly installed.
SDC>adiag" Auto Diag Extended PB memory detected. FLASH (OS) Checksum:OK NOVRAM Checksum:OK � � � * When the MY-72 board is installed
4. If an error is detected, the error code and the error message (surrounded by the dotted lines in the figure below) appear. Refer to section 2-3 and replace the defective parts.
� � � Path F (Pb Main Memory):OK Path G (Rec Main Memory):OK No Error. Auto Diag Finished. SDC> Auto Diag Finished. SDC> � � SRAM:NG 2 � � Path F (Pb Main Memory):OK Path G (Rec Main Memory):OK Error Codes 15:SRAM2 ERROR
<When an error is not detected>
<When an error is detected>
BKSI-2010
2-3(E)
|
|
|
> |
|
