|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
 ;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
 ;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
 ;
excellent service - fast purchase - easy download - will buy from again
 ;
Manual is actually a pack of schematics, good quality pictures.
2-1-5. How to Attach the Hard Disk Drive Unit (BKSH-102G)
Notes: 1) The six hard disk drive (HDD) units are installed in the media unit (VSH-1000) when the media unit (VSH-1000) is connected to the media control unit (VSR-1000) and used. 2) A maximum of six HDD units can be installed in a media unit when a media unit (VSH-1000) is connected to the MPEG-2 encoding unit (VST-1000/1000P) and used. 3) Never subject the HDD units to severe shocks. 1. Confirm that the POWER switch of HDD unit is in the OFF position. 2. Remove the four screws and remove the front panel. 3. Remove the two screws and remove the blank panels. Note: Remove the blank panels corresponding to the HDD units to install.
Screws PSW 3�8
Screws B 3�6
Front panel
Screws B 3�6
4. Align the rails of the HDD unit with the guide rails of the unit. 5. Move the top eject lever of the HDD unit in a level. Insert the HDD unit until the eject lever contact the unit with the bottom eject lever opened in the direction shown by arrow 1. 6. Insert the eject levers in the direction of arrow 2 and lock them. (The HDD unit is inserted to its end.)
(Lever in a level)
Guide rail
Rail
Guide rail 2 HDD Unit Power switch 1 Eject lever
Media unit
2-4
|
|
 |
> |
|