|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
So usefull to make my installation a breeze. 5 stars on quality.
;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Good copy and great customer service! There was some confusion with my order and it was resolved promptly!
16
Troubleshooting the BL-WV10A
Issue You cannot use Quick Setup.
Causes and Solutions Quick Setup will work for a maximum of 8 cameras. Is the Ethernet cable connected properly? If the Ethernet cable is connected properly, the LAN indicator will be lit green. Quick Setup can only be performed within 20 minutes of turning on a camera that still has its default settings (as at time of purchase). � Turn the camera on again. When performing Quick Setup on the BL-C30A, is the camera switch set to wired? When performing Quick Setup on a computer for cameras already initialized, is the IP address the same as that for the BL-WV10A? �
No router is displayed, even though one is connected.
Was the router turned on before the BL-WV10A? � Turn the router on and wait a minute or more before turning the BL-WV10A on. Is the DHCP server option in the router settings turned off? � Quick Setup cannot be performed.Launch the BL-WV10A in normal mode, and manually perform network settings from the Setup menu.
Display indicates no wireless router.
This appears when the BB-HGW700A is not connected. Each device is initialized with different wireless data settings, but can be used as is. Are the wireless settings for the BB-HGW700A configured to not use wireless options? �
Display indicates that no wireless router was found.
Are the wireless settings for the BB-HGW700A configured for the 802.11a communications mode? � If the BL-WV10A is used as a repeater, use a communications mode other than 802.11a for the BB-HGW700A. If the BL-WV10A is used as an access point, launch in normal mode, and then manually input the settings in the Wireless section of the Setup menu.
152
|
|
|
> |
|
