I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 276 (click to view)
Tuning instruments (Tuner)
For example, when the right tuning guide is lit, it indicates that the string�s pitch is higher (or sharper) than the correct pitch, and you should loosen the corresponding peg. On the other hand, when the left tuning guide is lit, it indicates that the string�s pitch is lower (or flatter) than the correct pitch, and you should tighten the corresponding peg.
If you do not want the sound being tuned to be routed to the LINE OUT or headphone jacks, either turn down the INPUT LEVEL knob or lower the MASTER fader. Note that it may not be possible to perform tuning if the INPUT SENS knob is turned down.
When the pitch is higher than the displayed note
If you are tuning a guitar with a vibrato arm, tuning of one string may cause the tuning of the other strings to drift. In such a case, you should carry out rough tuning in such a way that the correct note is displayed for each string, and you should then repeatedly fine-tune each string until all have been tuned.
When the pitch matches the displayed note
When the pitch is lower than the displayed note 6. Repeat Steps 4 through 5 to tune all of the instrument�s strings. 7. When you have tuned all of the strings, press [TUNER ON/OFF] or press [EXIT/NO]. The tuner will be turned off.
Precautions for tuner usage � Neither playback nor recording is possible while the tuner is being used. Effects will also be inactive at this time. � Ensure that only the sound to be tuned is played. If any other sounds are included in the audio input, it will not be possible to use the tuner correctly. � The tuner will not be able to correctly determine pitches when the level of the input source is too high or too low. If you are having trouble tuning an instrument, try adjusting its input volume using the corresponding INPUT SENS knob.
