|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Relocating the main controls
The main controls can be relocated to the bottom surface or right panel of the monitor depending on such factors as where and how the monitor will be used. <Note> Before relocating the main control, make absolutely sure that the power has been turned off.
1
Disconnect the cord connecting the main controls to the main unit.
Take hold of this part and pull it free to disconnect the cable.
4
Use the two screws to secure the main controls to the right panel.
2
Remove the screws on the right panel of the main unit.
5
Plug the cord connecting the main controls into the connector on the main unit and secure it. <Note> Using too much force to plug in the cord at the wrong insertion angle may damage the pins inside. Check out the shape of the connector before plugging it in.
Plug in the connector until it clicks into place.
3
Remove the two screws, and remove the main controls from the main unit. These two screws cannot be removed from the main controls themselves.
6
Secure the two screws, which were removed in step 2, in the screw holes on the bottom of the monitor.
8
|
|
|
> |
|
