|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0409030000.html
4.9.3 Adjustment Procedure
TOP PREVIOUS NEXT 1. Input an NTSC monoscope pattern signal and check that the picture locks horizontally. 2. Set the SCAN switch to over-scanning mode (original size). 3. Set the monitor to the FACTORY mode and select DISPLAY REF from the menu. 4. Adjust H POSI and V POSI on the DISPLAY REF menu to position the center of the picture at the center on the front of the picture tube. 5. Adjust H SIZE and V SIZE on the DISPLAY REF menu to obtain a horizontal scale of 2.5±0.3 and a vertical scale of 2.0±0.3 as a screen size. 6. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 7. Set the ASPECT switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. 8. Set the SCAN switch to over-scanning mode (original size) and change the input signal to a PAL Philips pattern signal. 9. Set the ASPECT switch to the 4:3 mode and check that the center of the picture is positioned at the center on the front of the picture tube. 10. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 11. Set the ASPECT/ switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. �@ TOP PREVIOUS NEXT
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0409030000.html [2006-02-04 08:28:39]
|
|
|
> |
|
