|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The AKAI 1720 model reel to reel tape recorder described in this Manual is quite an old unit - circa late 1960's. As a consequence, the description of the mechanical details - and adjustments thereof - is quite critical. The manual does this quite well. The schematics are also well presented and have detailed PCB overlays. Probably the only negative is that some half-tone detail has been lost from the original manual as it has been scanned in simple B&W.
 ;
Perfect source for service manuals: fast and professional transaction; high quality, perfect readable and largely scaleable PDF; complete schemes, diagrams and spare part list. Tnx a lot, cu again!!!!
;
I got your link from a friend and I must say that I am really satisfied with your service. Specially this B&O manual I didn't find anywhere on the web... but you could deliver it :-) . You deliver very fast and the copy is of good quality. So your webpage is bookmarked. Thanks
;
This was the Sony CCU-500A Service manual I was looking for.
The price was reasonable.
The permission to download was quck.
I will use Owner-Manual.com for all my manual needs.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
Powered Subwoofer
BU1
BU1 TEST PROCEDURE
TEST PROCEDURE
Equipment needed:
n n n n
7. Turn on generator and adjust so that speaker level output
is 1.0V, 50 Hz. Turn VOLUME control full clockwise. be heard and felt from port tube opening.
8. Green LED should light, immediate bass response should
Function/signal generator/sweep generator Integrated Amplifier Multimeter Cables - line level (RCA) and speaker cables
Sweep Function 1. Follow steps 1 - 4 above, using a sweep generator as a
signal source.
General Function UUT = Unit Under Test 1. Connect both right and left line level inputs (RCA) to
2. Sweep generator from 20Hz to 300Hz. Listen to the
cabinet and drivers for any rattles, clicks, buzzes or any other noises. If any unusual noises are heard, remove driver and test.
signal generator and UUT. Use Y-cable if necessary from mono source. VOLUME control should be full counterclockwise.
2. Turn on generator, adjust to 25mV, 50 Hz. 3. Plug in UUT; red LED should be ON. Turn VOLUME
control full clockwise.
Driver Function 1. Remove driver from cabinet; detach + and - wire clips.
2. Check DC resistance of driver; it should be 3.3 ohms. 3. Connect a pair of speaker cables to driver terminals.
speaker level output is 5.0V. Cables should be connected to an integrated amplifier fed by a signal generator. Turn on generator and adjust so that
4. LED should turn Green; immediate bass response should
be heard and felt from port tube opening.
5. Turn off generator, turn VOLUME control fully
counterclockwise, disconnect RCA cables.
4. Sweep generator from 20Hz to 1kHz. Listen to driver for
any rubbing, buzzing, or other unusual noises.
6. Connect one pair of speaker cables to either high level
input terminal on UUT. Cables should be connected to an integrated amplifier fed by the signal generator.
3
|
|
|
> |
|
