|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
1-5. Replacement of CRT
1-5. Replacement of CRT
1. Loosen the screw of the MIC clamp and open the MIC clamp. 2. Remove the three screws and remove the upper chassis.
Upper chassis
5. Remove the three screws and remove the CRT from the VF tube assembly. 6. Remove the CRT tube from the CRT.
MIC clamp
CRT
PTP2.6 � 8 VF Tube assembly
Lug PTP2.6 � 8 PTP2 � 6
BOLT,HEXAGON SOCKETS 2.6 � 6
7. Remove the four screws and remove the mask spacer. 8. Disconnect the connectors CN21 on LP-84 board and CN31 on LP-85 board.
Mask spacer
3. Disconnect the three connectors CN2, CN4 and anode cable of the VF-60 board. 4. Remove the CRT socket from the CRT.
CRT
Anode cable CRT cable
K2 � 5 LP-84
K2 � 5 CN21
CRT
CN31
LP-85
CN4 VF-60 CN2
9. Install a new CRT in the reverse procedures of removal. n When installing the upper chassis, take care not to clamp the harness between upper and lower chassis.
BVF-10 (UCJ) BVF-10CE (CE)
1-3 (E)
|
|
|
> |
|
