|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
1-6. Cleaning
1-6. Cleaning
1-6-1. Cleaning of Viewfinder
By extracting VF tube sub assy, lens and MC protector can be easily cleaned. And also dust on the CRT surface or mirror can be easily cleaned off. 1. Turn the hold ring to the left and extract the VF tube sub assy. 2. Detach the eyecup. 3. Remove the MC protector with the filter holder. 4. Clean the lens and MC protector with a commercially available camera lens cleaner. Blow off dust with a blower carefully so as not to flaw the mirror. 5. After the cleaning is completed, install by reversing the preceding steps. Align red lines of the VF tube and VF tube sub assy when inserting, and turn the hold ring to the right until it locks. m . Do not use any type of solvent, such as alcohol, benzine or thinner to remove stains. . Be sure to attach the eyecup to the VF, or the MC protector may come off. . To protect the viewfinder lens from drops, put the MC protector in the filter holder and attach the eyecup securely.
1-6-2. Cares After Using at Special Environment
It is recommended to check the following items after gathering the news at seaside, dust area or spa. 1. Clean off sand and other dust in the unit carefully. 2. Do not allow salt in seawater or sulfur in spa to contact a not-painted surface of the cabinet. They may cause to corrode. Clean with alcohol immediately if contacted. 3. Clean the connection surface of connectors. 4. Carry out the common operation check and check that the unit normally operates.
Hold ring
Align red lines
VF tube sub assembly
MC protector Filter holder Eyecup
BVF-V10/V10CE
1-3 (E)
|
|
|
> |
|
