|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
2-2. Upgraded BVP-500/500P with BKP-5090 2-2-1. Gain Adjustment 2-2-2. V Substrate Voltage/V Reset Gate Adjustment
8. G Gain Adjustment (1) S650 (MONITOR OUT)/on the panel of the IF538 board � VF G button/on the rear panel � ON R/B button/on the rear panel � OFF (2) GAMMA OFF button/MSU operation panel � OFF (light up) (3) Test Point : MONITOR connector Adjustment Point: 1RV300 (G GAIN)/VA panel Specification : C = 100 ± 2 IRE
2-2-2. V Substrate Voltage/V Reset Gate Adjustment
Notes: This adjustment can be performed using the Factory menu. Pay attention when the Factory menu will be changed. Be sure not to set the needless menu item. Equipment : Oscilloscope, Color monitor Object : Pattern box Preparations: . Set S1-1 to S1-4 on the AT-126 board to ON. The Factory menu can be seen on the viewfinder screen. . MASTER GAIN button/MSU operation panel � 0 dB . ECS/SHUTTER control section/MSU operation panel ECS button, ON button � OFF . DETAIL OFF button/MSU operation panel � OFF (light up) . GAMMA OFF button/MSU operation panel � ON (go off) . Extend the VA-163 board with the EX-464 board. Adjustment Procedures: 1. Open the lens iris. Shoot the pattern box. Adjust the size of pattern box on the viewfinder screen with zoom control of the lens.
C
(Oscilloscope)
9. Select D section on the waveform monitor. 10. Set the waveform monitor to CHROMA mode. 11. S650 (MONITOR OUT)/IF-538 panel � VBS 12. Test Point : MONITOR connector Adjustment Point: 1RV200 (R GAIN)/VA panel 1RV400 (B GAIN)/VA panel Specification : Minimize the carrier leakage E.
Pattern box D
Monitor Screen (Viewfinder Screen) 15 LINE
2. Open the Factory menu. Adjustment Point: MENU : Factory PAGE : Board Config (F4)
E
E = MINIMUM (Waveform Monitor)
Resetting after Adjustment: . KNEE OFF button/MSU operation panel � ON (go off) . GAMMA OFF button/MSU operation panel � ON (go off) . G button/on the rear panel � OFF
BVP-570/550/500
2-7 (E)
|
|
|
> |
|
