|
|
|
Who's Online
There currently are 5973 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
http://getMANUAL.com
2-3. Cares after Using at Special Environment 2-4. Error Message in Automatic Adjustment Mode
2-3. Cares after Using at Special Environment
It is recommended to check the following items after using the camera at seaside, dust area or spa. 1. Clean off sand and other dust in the unit carefully. 2. Do not allow salt in seawater or sulfur in spa to contact a not-painted surface of the cabinet. They may cause to corrode. Clean with alcohol immediately if contacted. 3. Clean the connection surface of connectors. 4. Carry out the common operation check and confirm that the unit normally operates.
2-4. Error Message in Automatic Adjustment Mode
If an error occurs during automatic adjustments, an error message appears on a viewfinder screen. Take following measures according to the displayed message. 1 �OVER FLOW� The adjusted value overflowed the adjustable range. Check whether the settings on the camera are correct or not. If they are correct, adjustments of the internal boards are necessary. If adjustments of the boards are required, contact your local Sony Sales Office/Service Center. 2 �LOW LEVEL� The video signal level was too low for white balance or skin detail phase adjustment, and the white balance or skin detail phase could not be adjusted. Raise the video signal level by using brighter illumination, opening the lens iris, or raising the gain of the video signal. 3 �TIME LIMIT� Automatic adjustment did not finish within a specified period. Check whether the settings on the camera are correct or not. If they are correct, adjustments of the internal boards are necessary. If adjustments of the boards are required, contact your local Sony Sales Office/Service Center. 4 �NOT CLOSE� The lens did not close for black balance or black shading adjustment. 5 �LOW SATURATION� The saturation of subject was too low for skin detail phase adjustment, and color tone could not be discriminated. Raise the video signal level by using brighter illumination, opening the lens iris, or raising the gain of the video signal. 6 �OVER LEVEL� The video signal level was too high for white balance or white shading adjustment, and the color tone could not be discriminated. Lower the video signal level by using brighter illumination, closing the lens iris, or to lower the gain of the video signal. Other message . �BREAK� The automatic adjustment was interrupted with the BREAK command.
BVP-950 P1
2-3 (E)
|
|
|
> |
|
