|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
;
Great quality complete service manual!!! complete parts list and drawings
;
Again a great job. I never been disilluted from them! Clear scheme, complete and very good for repairing!
;
Great manual just what I needed, great service as always, thanks.
1-2. Note in Replacing the TG Board
1-2. Note in Replacing the TG Board
When replacing the TG-121 or TG-163 board with a new one, remove the PROM on the new board and replace it with the PROM that was mounted on the former TG-121 or TG-163 board. TG-121 board (B side) : IC2 TG-163 board (A side) : IC11 Note in Replacing a PROM To remove a PROM, remove its socket frame. This socket frame is so fragile. When removing the socket frame, therefore, it is recommended to use a special removing tool listed below. If it is not available, use a small slotted screwdriver or similar item as a substitute for it. To remove the socket frame by using a screwdriver, proceed as follows. IC socket removing tool: Sony part No. J-6394-110-A Socket frame: Sony part No. 1-540-194-12 Removing a socket frame (by using a screwdriver) Insert the screwdriver as shown in the figure and push it lightly in the direction of the arrow to unhook the frame socket.
Screwdriver Socket frame Claws
Claws PROM
TG-121 board IC2 IC11
TG-163 board
1-2 (E)
BVW-300/300A
|
|
|
> |
|
