|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
;
Very good detail, Quick service response. A useful service manual with all details. I recomend this service.
1-2. Note in Replacing the TG Board
1-2. Note in Replacing the TG Board
When replacing the TG-121 or TG-163 board with a new one, remove the PROM on the new board and replace it with the PROM that was mounted on the former TG-121 or TG-163 board. TG-121 board (B side) : IC2 TG-163 board (A side) : IC11 Note in Replacing a PROM To remove a PROM, remove its socket frame. This socket frame is so fragile. When removing the socket frame, therefore, it is recommended to use a special removing tool listed below. If it is not available, use a small slotted screwdriver or similar item as a substitute for it. To remove the socket frame by using a screwdriver, proceed as follows. IC socket removing tool: Sony part No. J-6394-110-A Socket frame: Sony part No. 1-540-194-12 Removing a socket frame (by using a screwdriver) Insert the screwdriver as shown in the figure and push it lightly in the direction of the arrow to unhook the frame socket.
Screwdriver Socket frame Claws
Claws PROM
TG-121 board IC2 IC11
TG-163 board
1-2 (E)
BVW-300/300A
|
|
|
> |
|
