|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Using the Optional SP01 Shock-Mount
Using the Optional SP01 �Spider� Shock-Mount
For additional isolation, the C03 can be fitted on the optional SP01 �Spider� shock mount. Follow the steps below the to install the SP01. � First, screw the SP01 shock mount onto your mic stand or boom arm. If you�re using a US 5/8� mic stand or boom, remove the Euro adapter. Remove the C03 swivel mount by rotating the threaded collar counterclockwise as shown in figure 1. Install the C03 into the SP01 by fitting the microphone into the center of the web, positioning the C03 onto the bottom mounting plate. Secure the SP01 by reinstalling the threaded collar, rotating clockwise until tight. (Figure 2) � Now, loosen the thumb screw to adjust the angle of the microphone and position the C03 to the desired location. Once set, tighten the thumbscrew to secure the microphone in place. Note: Be careful not to cross thread or over tighten the threaded collar or thumb screw.
1
0
-10dB
�
�
�
THREADED COLLAR
2
0
-10dB
SP01 SHOCK MOUNT
THUMB SCREW THREADED COLLAR
7
|
|
|
> |
|
