|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
Block Diagrams
9. Block Diagrams
9-1 C15A Video Block Diagram
9-1-1 Notes
The TV�s 1st and 2nd tuners (and VCR module) are �multi-system.� compatible: IC201 (TDA8842/8841) is the video, chroma, and deflection (VCD) IC .
9-1-1(A) TAPE PLAYBACK (REGARDLESS OF ORIGINAL RECORDING SYSTEM)
If the output PB signal of micom pin 6 is high, the PB signal outputs from module deck 2, passes through IC 702 pins 2 and 3 and out to another VCR . The output signal of IC701 pin 1 (pin 15) outputs from IC201 pin 17 .
9-1-1(B) VIEWING NORMAL CHANNEL WHILE RECORDING A SCRAMBLED CHANNEL:
The output CVBS (Composite Video Signal) of the 2nd IF outputs to IC702pin 3 when the micom�s pin 7 V/T/H (VCR tuner high) is high . The decoded signal goes to IC701 pin 2, where it is fed to IC 701 pin 4 (high output of micom�s� pin 8� AV/Tuner), and out to VCR pin 4 (module deck) for recording.
9-1-1(C) VIEWING A SCRAMBLED CHANNEL WHILE RECORDING AN UNSCRAMBLED CHANNEL.
The output CVBS of the 2nd IF is fed from IC701 pin 5 to IC701 pin 4 (low output of micom pin 8�AV/tuner). Then it goes to the module deck pin 4 for recording. The scrambled signal (CVBS) is fed to IC702 pin 1 through the 1st IF, and then to IC702 pin 3 (micom�s pin 7, V/T/H registers low). Then it goes to the decoder input. The descrambled signal goes to IC701 pins 2 and 15 (PH high output of micom�s pin 6), and then to IC201 pin 17, where it outputs as RGB.
9-1-1(D) SYNCHRONOUS RECORDING:
The viewer sees the signal from the 1st tuner , while the signal from the second tuner is recorded. Audio processing for the French system type is shown in the table.
Samsung Electronics
9-1
|
|
|
> |
|
