|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased a copy of my old JVC VCR Service manual from Owner-Manuals.com
The copy was complete and valuable to me.
I was able to fix my VCR - it had a bad belt.
I am glad I found Owner-Manuals.com
Great Price. Thanks
 ;
Great service! I got manual to my sony receiver for very reasonoble price.
 ;
Good service, well organized. Cheap, and the service manual was as expected. A valuable service for those of us wanting to keep the old junk going!
 ;
The manual arrived very quickly and had all the information I needed - Very satisfied with this seller. - Thanks -
 ;
Good quality, the manual help me to repair the echo/reverb section
2. Installation
1. Using desoldering braid, remove the solder from the foil of each pin of the flat pack-IC on the CBA so you can install a replacement flat pack-IC more easily. 2. The � � mark on the flat pack-IC indicates pin 1.
�
Instructions for Handling Semiconductors
Electrostatic breakdown of the semi-conductors may occur due to a potential difference caused by electrostatic charge during unpacking or repair work.
(See Fig. S-1-7.) Be sure this mark matches the 1 on the PCB when positioning for installation. Then presolder the four corners of the flat pack-IC. (See Fig. S-1-8.) 3. Solder all pins of the flat pack-IC. Be sure that none of the pins have solder bridges.
1. Ground for Human Body
Be sure to wear a grounding band (1 M�) that is properly grounded to remove any static electricity that may be charged on the body.
2. Ground for Workbench
Be sure to place a conductive sheet or copper plate with proper grounding (1 M�) on the workbench or other surface, where the semi-conductors are to be placed. Because the static electricity charge on clothing will not escape through the body grounding band, be careful to avoid contacting semi-conductors with your clothing.
Example :
<Incorrect>
Pin 1 of the Flat Pack-IC is indicated by a " " mark. Fig. S-1-7
Presolder CBA
Flat Pack-IC CBA Fig. S-1-8
<Correct>
Grounding Band
1M�
CBA
1M� Conductive Sheet or Copper Plate
1-3-3
VCRN_SN
|
|
 |
> |
|