|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
good scans, all is clear. all pages in order. recommended
 ;
Très-très bon site, facile, très bon prix.
Au futur besoin, je n’hésiterais à faire appel à vous.
Merci
;
This is the correct service manual of SHARP RX-100H(BK) DAT.
;
The ervice manual for my 1982 Kenwood KR-1000 receiver is great! Full detail on all circuits with part number detail. I will definately be ordering more manuals for my other vintage equipment! Order was fulfilled quickly! Very efficient ordering process! Thnaks for your help! Great site!
;
Everything in the manual was excellent except for a couple of pictures of specific areas in the unit that were a little dark. Owners Manuals re-sent the pdf file & the problem was corrected. Excellent product! George
2-7. Replacement of Board
2-7. Replacement of Board
2-7-1. Replacement of FL-180 Board
n Every electrical part mounted on the FL-180 board cannot be replaced. If there is any defective part, replace the board itself. 1. Remove the right side panel and top panel referring to Section 2-1. 2. Remove the four screws to remove the CA plate. 3. Remove the six screws to remove the MIC connector panel.
5. Lift out the FL-180 board and disconnect CN1 from the board.
CN1
6. Install a new board in the reverse procedures of the removal.
K3 X 6 CA plate
Precision P2.6 X 8
K3 X 6 Precision P2.6 X 5
Precision P2.6 X 8
MIC connector panel
Precision P2.6 X 5
4. Disconnect the two connectors, CN1 from the converter and CN4 from the FL-180 board. Remove the two screws securing the FL-180 board.
CN1
B2.6 X 5 CN4
B2.6 X 5
2-4 (E)
CA-550 CA-550P
|
|
|
> |
|
