|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
 ;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
;
Perfect like it was descriped, Perfect like it was descriped
;
Very good detail, all pages clear, exactly what I needed
1-3. Connection Input/Output Signals
Note 1 : Specifications of BATT IND Signal VTR has a battery voltage detection and waring signal generation circuits and it sends the signal shown below to the camera.
Battery Terminal Voltage (VTR internal battery) 12.0�11.1 Vdc 11.1�10.8 Vdc 1.0 ± 0.2 Hz duty 50 ± 10 % Input Signal at Pin 25 0V LED on Viewfinder Stays out Blinks at 1 Hz Lights up 10.8 Vdc or less
2�3 Vdc across 300 �
Note 2 : Specifications of REC ALARM Signal
+1 5.0 -0.5 Vdc Input Signal at Pin 24 2.5 ± 0.5 Vdc REC TALLY signal 1.0 ± 0.2 Hz duty 50 ± 10 % Power ON When VTR changes from POWER SAVE to REC START mode, or when the servo is lost
0 ± 0.3 Vdc Power OFF VTR Action
REC RESET signal 10�100 msec When VTR changes from STANDBY to REC START mode, or in REC mode At the end of STOP tape or When mode VTR is put into STOP mode by itself (REC RESET signal does not appear when VTR is put into STOP mode by operating the camera)
Note 3 : Specifications of TAPE REM Signal
Tape Remaining (VTR) TAPE1 +5 V +5 V 0V 0V TAPE2 +5 V 0V +5 V 0V +3.4 V +3.1 V +2.2 V 0V G TALLY lamp lights at +3.1 V (in connection with CCU) Input Signal at Pin 25 Remark
1-4 (E)
CA-553
|
|
|
> |
|
