|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
1-8. Replacement of AC.DC/DC Convertor
1-8. Replacement of AC.DC/DC Convertor
CAUTIONS To avoid electric hazards, the power to the unit should be turned off during replacement. Before beginning replacement, be sure not only to turn off the power switch but to disconnect the cables from the TRIAX or DC IN connector. The power block will go very hot during operation. If you remove the side panel and touch the power block, there is some danger to get burned. When you open the side panel for replacement, please allow for at least 10 minutes after powering off until the inside cools off. n Every electrical part used in the AC.DC/DC convertor cannot be replaced. If there is any defective part, replace the convertor block itself.
3. Remove the three screws and pull out the AC.DC/DC convertor. 4. Disconnect the three connectors.
Press to unlock
B3 B3 Connectors 5
5
1. Remove the right side panel. (Refer to Section 1-5.) 2. Disconnect the IF-607 board.
AC.DC/DC convertor
5. Remove the two screws and remove the retainer.
Retainer
B3
4
IF-607
6. Install a new AC.DC/DC convertor in the reverse procedures of the removal.
CA-755/755P
1-11 (E)
|
|
|
> |
|
