|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
2-4. Replacing the MB-726 Board
4. Remove the four screws shown in the figure, and remove the optical cable unit.
Optical cable unit
6. Disconnect the harnesses from the connectors (CN8, CN12, CN13, CN15, CN19, CN20, and CN23) of the MB-726 board, the coaxial cable from the connector (CN26), and flexible card cable from the connectors (CN6, CN7). 7. Disconnect the harnesses from the connectors (CN9, CN11, CN25) on side A of the MB-726 board, and the flexible card cable from the connectors (CN10, CN17). 8. Remove the four supports, and remove the MB-726 board.
< Side A > < Side B >
Precision P2.6 x 4
CN9 CN17 CN19 CN20 CN8 CN11 CN25 CN7 CN23 CN6 CN12 CN13
CN15
CN10
Precision P2.6 x 4
5. Disconnect the flexible card cable from the connectors (CN1, CN2, CN3) of the SDI-30 board and remove the SDI-30 board.
SDI-30 board
MB-726 board
Supports
CN3
CN26
CN2 CN1
Supports
9. Attach the new MB-726 board in the reverse order of steps 1 to 8.
2-6 (E)
CA-950/950P MM V1
|
|
|
> |
|