|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
2-4. Replacing the MB-726 Board
4. Remove the four screws shown in the figure, and remove the optical cable unit.
Optical cable unit
6. Disconnect the harnesses from the connectors (CN8, CN12, CN13, CN15, CN19, CN20, and CN23) of the MB-726 board, the coaxial cable from the connector (CN26), and flexible card cable from the connectors (CN6, CN7). 7. Disconnect the harnesses from the connectors (CN9, CN11, CN25) on side A of the MB-726 board, and the flexible card cable from the connectors (CN10, CN17). 8. Remove the four supports, and remove the MB-726 board.
< Side A > < Side B >
Precision P2.6 x 4
CN9 CN17 CN19 CN20 CN8 CN11 CN25 CN7 CN23 CN6 CN12 CN13
CN15
CN10
Precision P2.6 x 4
5. Disconnect the flexible card cable from the connectors (CN1, CN2, CN3) of the SDI-30 board and remove the SDI-30 board.
SDI-30 board
MB-726 board
Supports
CN3
CN26
CN2 CN1
Supports
9. Attach the new MB-726 board in the reverse order of steps 1 to 8.
2-6 (E)
CA-950/950P MM V1
|
|
|
> |
|
