This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 14 (click to view)
English
AM (MW/LW) antenna
Connecting Speakers
You can connect a pair of the front speakers.
1
2
3
1
Vinyl-covered wire (not supplied)
ANTENNA
FM 75
COAXIAL
2
3
CAUTION: SPEAKER IMPEDANCE 6~16 OHMS.
Red Speaker cord
SPEAKERS
AM EXT AM LOOP
Speaker cord
GND
RIGHT
LEFT
Black
AM (MW/LW) loop antenna (supplied)
1 Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
Right speaker
Left speaker
2 Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM (MW/LW) loop antenna must remain connected.)
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
For better reception of both FM and AM (MW/LW) � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.