JVC CA-MXJ500B
Owner's Manual

1 Press and hold the clamp of the speaker
terminal on the rear of the unit.

To connect audio equipment with an optical digital input terminal
You can record CD sound onto the connected digital equipment.
Protective plug

2 Insert the end of the speaker cord into the
terminal.
Match the polarity (color) of the speaker terminals: ª to ª and · to ·.

3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

Connecting Other Equipment
You can connect both analog and digital equipment.
� DO NOT connect any equipment while the power is on. � DO NOT plug in any equipment until all connections are complete.

Before connecting the other equipment, remove the protective plug from the terminal. Audio equipment with an optical digital input

To optical digital input

To connect an analog component
Be sure that the plugs of the audio cords are color coded: White plugs and jacks are for left audio signals, and red ones for right audio signals.

Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the CD OPTICAL DIGITAL OUTPUT terminal.

NOW, you can plug in the unit and other connected equipment FINALLY!
When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration. To stop the display demonstration, press any button on the unit or on the remote control.

Audio/video equipment To audio output

For playing the other equipment through this unit, connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).

To start the display demonstration manually

Press and hold DEMO for more than 2 seconds.

To stop the demonstration, press any button.

�8�