|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
C-AX10
When the front flip-down door is opened
0-=
~ !@ # $
DOLBY
DIGITAL
%^ &*()_ + ¡ �
% CHARACTER INPUT buttonV This button is used to enter the Character Input mode for changing the input signal or sound memory setting to a user-selected name. ^ Digital REC Selector button (REC SELECTOR [DIGITAL] )V This button is used to enter the mode for selecting the REC OUT signal that is output from the digital output jack. & INPUT GAIN buttonV This button is used to enter the mode for adjusting the analogue input and digital input gain. * PARAMETER CHECK buttonV This button is used to enter the mode for checking the current settings. ( Tone Control button (TONE)V This button is used to enter Tone Control mode. ) Tone Control Channel button (EACH/ALL)V This button is used to switch between EACH mode and ALL mode. ÷ EACH mode : The front, centre, and surround channels can each be set individually. ÷ ALL mode : The front, centre, and surround channels are set to the same settings.
_ Balance Control button (BALANCE) V This button is used to enter the mode for adjusting the balance of the front left and right channels. + SYSTEM SET UP buttonV This button is used to enter System Setup mode for speaker setup or selecting modes. ¡ NETWORK SET UP buttonV This button is used to enter Network Setup mode when the OUTPUT MODE selector (�) is set to Digital Network FIR mode or Digital Network IIR mode. � OUTPUT MODE selector This selector is used to set to one of the following four modes. ÷ Digital Network FIR mode ÷ Digital Network IIR mode ÷ Normal mode ÷ OFF (Output off)
V After pressing the buttons in % to ¡, use the MULTI CONTROL jog dial 8 to make the settings and adjustments.
114
|
|
|
> |
|
