BRANDT CB2900E
Owner's Manual

Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).

8mm

K Ha

Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.

Hb
PR168

Fix cover (Hd) on guide (Hb) until it clips into place.

Hb

Hd
PR167/1

If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (D), move them as shown in Fig. and then fasten them up again. Fit the cover (E).

D E

D734

After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. 15