|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
 ;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
;
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
;
Superb! It's the original manual. We can now use our old calculator with its full function.
Whenthe control knobis turned ON, gas will flow intothe burner. The solid state igniter will click as long as the knob is in the Lite position. (Note: All burner igniters will spark regardlessof which burner is being operatedwhen a knob isturned to the Iite position.) A properly adjusted burner with clean ports will light within a few seconds. On natural gas, the flame will be blue with a deeper blue inner core. There should be no trace of yellow in theflame. A yellowflame indicatesan impropermixtureof air/gas. This wastes fuel, so havea servicemanadjust the mixtureif a yellow flame occurs. On LP gas, some yellow tipping is acceptable. This is normal and adjustment is not necessary. The infinite surface controls provide flexibility in heat setting selection. (See page 7,)
In case of prolonged powerfailure, youcan manuallylight the surfaceburner by holding a lightedmatchnearthe burnerportsand slowlyturningthe controlknobcounterclockwise (after depressing) to the LJte setting. CAI,ITION: When lightingthe surface burner, be sure all of the controlsare in the OFF position. Strike the matchfirst and hold it in position beforeturning the knobto the Lite position. Note: Becauseyour overhead hood fan is electricit will notwork during a power failure so smoke and condensationcan gather.
COUNTERCLO£;KWlSE
The Lo setting should produce a stable flame when turning the knob from Hi to Io. The flame should extend to the outer edge of the lip of theburner capon the Lo settingand must be stable on all ports on Lo setting. To adjust" Operate burner on Hi for about 5 minutes to preheat burner cap. Turn knob back to Lo; remove knob, and insert a small screwdriver into the center of the valve stem. Adjust flame size by turningadjustment screw in eitherdirection while holdingthe valve stem securely.
t TO,NCREASE _LAME _ _1 SLzE CLOCKW,SE.IIII A TO REDUCE FLAME SIZE
STEM
,
,
VALV W
Flame must be of sufficientsize to be stable on all burner ports. If flame adjustment is needed,adjust ONLY on the Lo setting. Never adjust flame size on a higher setting. Note: All gas adjustments should be done by a qualified servicer only. 6
|
|
|
> |
|
